LAW.coLAW.co

John Mutter vs. Lawrence Manufacturing Company

Massachusetts Supreme Judicial Court1907-05-15
195 Mass. 517

Summary

Holding. The judgment for the defendant was properly entered because the experienced worker assumed the obvious risk of injury from the set screw, having full opportunity to inspect it and knowledge that it could be readily examined when the shaft was at rest, despite his failure to do so.

A factory worker was injured by a protruding set screw on a pulley shaft while performing work he had done many times before. The worker acknowledged knowing that set screws were typically used to fasten pulleys and that variations existed in their size and projection, but argued he had not assumed the risk of injury from this particular screw because it extended unusually far—two inches above the hub rather than the standard half to three-quarters of an inch—making it more dangerous than ordinary set screws.

The court rejected this argument, finding that the worker had full opportunity to inspect the screw when the shaft was stationary and could have readily observed its exact position, length, and angle of projection. The worker knew a set screw existed at that location, was aware that set screws varied in their specifications on the defendant's equipment, and consciously chose to work on the moving shaft without taking the time to examine the screw's actual characteristics despite knowing he could do so easily. Under these circumstances, the court concluded the worker assumed the risk of injury from the screw, regardless of whether it was more dangerous than the standard variety.

The court also rejected the worker's exception regarding excluded testimony about why the set screw was ordered removed, finding such information would not have been material to any issue in the case.

Summary generated by law.co from the public-domain opinion. The opinion text itself is public domain.

Key issues

  • Whether a worker assumes the risk of injury from a hazard that differs materially from the standard form
  • Whether knowledge of a general hazard combined with failure to inspect an obvious and readily observable danger constitutes assumption of risk
  • The duty of an employer to warn of or modify unusually dangerous equipment variations when the worker had means to discover them

Procedural posture

The plaintiff appealed from a jury verdict in favor of the defendant in a workplace injury action, raising exceptions to the trial court's rulings on evidence and the verdict itself.

Authorities cited

No cited authorities resolved to law.co cases yet.

Opinion

majority opinion

Sheldon, J.

The plaintiff contends that although he knew that pulleys were usually fastened to the shaft by means of set screws, and knew that there were set screws about the pulleys on which he was working although he had not actually seen them, and was instinctively trying to avoid them, yet he had not assumed the risk of injury from the set screw in question, because this differed from the kind ordinarily in use, in that it extended above the hub of the pulley a distance of two inches instead of the usual distance of half to three quarters of an inch, or, on large pulleys, an inch above the hub, and an eighth of an inch laterally beyond the line of the rim of the pulley instead of being wholly within that plane, — variations which might have been found on the evidence to increase materially the risk of injury from the screw when the shaft was revolving. His counsel admit in argument that if he had received his injury by coming in contact with a set screw of the kind ordinarily in use. upon pulleys like the one on which he was working, he must be held to have assumed the risk of such an injury, even though he never had actually seen this particular screw.

But the difficulty with his contention is that the situation, character and projection of this screw were perfectly obvious upon inspection. Apparently the only reason that the plaintiff did not know all these circumstances was that he never had worked upon this shaft except when it was in motion, and never had taken the trouble to look at it at any other time. Indeed he testified that he never saw this screw, either before or after the accident, and knew only what had been told him about it. The screw could not be distinguished when the shaft was in rapid motion, although there was no difficulty in seeing it when the shaft was at rest. He knew that there was a set screw here ; he knew that the screws in use on the defendant’s shafts were not uniform in size, length or extent of projection ; and he chose to work upon this pulley without ascertaining any of the particulars that he knew could be readily ascertained when the shaft was at rest, and could not be ascertained when it was revolving rapidly, as might have been found to be the case in Hale v. Cheney, 159 Mass. 268. The screw had been here for some years. The plaintiff was an experienced man. He had done the same work on this pulley a great many times before. He knew and had in mind the danger of getting his arm caught on this screw, and was instinctively trying to avoid it. He had had full opportunity to examine and acquaint himself with the exact circumstances, the nature, length and angle of projection of the screw which created the danger. All these circumstances were obvious if he had chosen to look for them. Demers v. Marshall, 178 Mass. 9. Donahue v. Washburn & Moen Manuf, Co. 169 Mass. 574. Rooney v. Sewall & Day Cordage Co. 161 Mass. 158. The case is stronger for the defendant than those cases in which the plaintiff did not know of the particular screw by which he was hurt. Kennedy v. Merrimack Paving Co. 185 Mass. 442. Archibald v. Cygolf Shoe Co. 186 Mass. 213. Ford v. Mount Tom Sulphite Pump Co. 172 Mass. 544. The defendant owed no duty to the plaintiff to make any change in this screw. Gleason v. Smith, 172 Mass. 50, 52. And the risk was none the less assumed because the character and position of this screw were more dangerous than is usually the case. McLeod v. New York, New Haven, & Hartford Railroad, 191 Mass. 389, 391. The verdict for the defendant was ordered rightly.

The exception to the exclusion of the question put to the witness Hamilton as to the reason for which he was ordered to remove this screw cannot be sustained. There is nothing to show what answer was expected, and it does not appear that the reason for such an order would be material to any issueuaised in the case. It is the plaintiff’s knowledge that the screw was in this place and his neglect to acquaint himself with the obvious circumstances that prevent him from recovering. When he undertook the work he was doing he assumed all the obvious risks of the business, including the risk of injury from the machinery and appliances which were then openly used. Rooney v. Sewall & Day Cordage Co. 161 Mass. 153. Kenney v. Ringham Cordage Co. 168 Mass. 278. Carrigan v. Washburn Moen Manuf. Co. 170 Mass. 79. The reason why the screw was put in this place or why its removal was afterwards contemplated was unknown to him and had no bearing upon his conduct.

We find nothing, in view of our previous decisions, to help the plaintiff in any of the cases to which he has referred us.

Exceptions overruled.